Innovative Solutions in Time and Frequency Synchronisation.
Meinberg USA Meinberg Homepage | RSS Feed | Contact Form

LANTIME M200/GPS : NTP Time Server with integrated GPS Reference Clock

  • Synchronization of NTP and SNTP compatible clients
  • Web based status and configuration interface and console based graphical configuration utility
  • Supported networking protocols: IPv4, IPv6, HTTPS, HTTP, SSH, TELNET, SCP, SFTP, FTP, SYSLOG, SNMP
  • USB port for performing updates, lock front panel, and backup/restore configuration and log files.
  • LC-display, 2 x 40 characters, with backlight
  • Antenna connected with up to 300m of standard coaxial cable RG58

Basic model with all the software features of a LANTIME M300. Available in a smaller housing as a desktop model and an optional rackmount kit in order to mount the unit in a 19 Inch rack.

Time Server M200/GPS Rear View

The M200 is limited to a TCXO and one network interface.

LANTIME M200 time servers can be installed to provide accurate time to small and medium sized computer networks. This entry level time server synchronizes all systems either NTP- or SNTP-compatible utilizing a built-in Meinberg GPS radio clock as its primary reference time source. A stable and precise oscillator is capable of bridging interferences or a temporary loss of reception.

The GNU/Linux operating system of the LANTIMEs SBC (Single Board Computer) has been optimized to ensure a high level of security and reliability.

A large LC display shows the state of the internal GPS receiver and the NTP subsystem. Three LEDs (green/red) indicate the status of the three main components: Reference Time (GPS), Time Synchronization Service (NTP) and Network (Link status). A fourth red LED is labelled ALARM and can be configured to signal any event that is covered by the notification handling routines.

The configuration of the system can be done by using a standard web browser for accessing the extensive but straightforward html interface. Alternatively a text based and menu driven setup utility can be started from the shell prompt after logging into the unit via Telnet or SSH.

The security-related features of LANTIME time servers satisfy highest demands. The time synchronization data can be reliably signed and secured by symmetric keys (MD5) and the NTP autokey procedures. In order to support network management systems the LANTIME time servers offer an extensive SNMP interface, which can be accessed by SNMP V1, V2.c and V3. It allows the monitoring of all relevant system parameters (including operating system parameters, network interface statistics, detailed GPS and NTP status information as well as the complete system configuration) and can be used to alter the LANTIME configuration via SNMP set commands, too.

LANTIME time servers are designed to be deployed in IPv6 networks, the NTP time synchronization as well as the configuration interfaces (Web-based, SSH and SNMP) comes with IPv6 support. You can assign several IPv6 addresses and the system supports automatic configuration by IPv6 autoconf.

The LANTIME M200 GPS is equipped with a high precision TCXO oscillator (please check our oscillator options page for technical specifications). The oscillator determines the holdover characteristics (e.g. when the GPS signal is disturbed or jammed).

For more information visit the Low Cost GPS NTP Time Server MEINBERG Page!


Downloads from Meinberg Homepage

Download Info SheetDownload Info Sheet: info_lantime-m200-gps.pdf
Download ManualDownload Manual: info_lantime-m200-gps.pdf

Meinberg-USA Download PageFor Software Downloads visit our Download Page


Interested in LANTIME M200/GPS : NTP Time Server with integrated GPS Reference Clock ?

Please fill in the Form - we send detailed informations to you immediately!

Your Name
Company Name
Your E-Mail Address *
Telephone
Address
City/Zip Code
State *
Your Message
Fields marked with * are mandatory!